

| パラメータ | 価値 |
|---|---|
| 514 Years (SN 29500 standard, temperature 40°C, operating cycle 34.25%) | |
| EMC | B |
| 平均故障間隔 | 823 Years (Telcordia standard, 25°C temperature, 21% operating cycle (5 days a week, 8 hours a day)) |
| 平均時間 | 1091 Years (SN 29500 standard, temperature 25°C, operating cycle 21%) |
| 注記 | Please follow the special installation instructions in the documentation! |
| 深さ | 121 mm |
| 入力 | ± 2 kV |
| 幅 | 35 mm |
| 身長 | 111 mm |
| 信号 | CAN |
| 電圧 | 10 V |
| 高度 | ≤ 5000 m (For restrictions, see the manufacturer's declaration for altitude operation) |
| コメント | Criterion B |
| 湿度 | A |
| ビット遅延 | One telegram length (EXTENDED) |
| 囲い | Required protection according to the Rules shall be provided upon installation on board |
| 振動 | A |
| CCCexノート | Use in potentially explosive areas is not permitted in China. |
| 証明書 | CE-compliant |
| 基準A | Normal operating behavior within the specified limits. |
| 基準B | Temporary impairment to operational behavior that is corrected by the device itself. |
| 出力名 | Relay output |
| 温度 | B |
| 製品タイプ | Interface converter |
| 組み立てノート | The product can be snapped onto all 35 mm DIN rails in accordance with EN 60715. |
| 取り付けタイプ | DIN rail mounting |
| 識別 | II 3 G Ex ec IIC T4 Gc |
| 騒音放出 | EN 55011 |
| ノイズ耐性 | EN 61000-6-2 |
| カラー(ハウジング) | green (RAL 6021) |
| 電界強度 | 10 V/m |
| 周波数範囲 | 80 MHz ... 3 GHz |
| チャンネル数 | 2 (CAN_High / CAN_Low) |
| 記事の改訂 | 09 |
| 空中放電 | ± 8 kV |
| 剥ぎ取り長さ | 7.00 mm |
| 接続方法 | COMBICON plug-in screw terminal block |
| 接触放電 | ± 6 kV |
| 出力数 | 1 |
| 締め付けトルク | 0.56 Nm ... 0.79 Nm |
| ファイル形式/コーディング | Bit stuffing, NRZ |
| 材質(ハウジング) | PA 6.6-FR |
| 伝送速度 | ≤ 1 Mbps (Configurable via DIP switches) |
| 寸法図 | |
| 申請に関する注意事項 | Only for industrial use |
| 伝送距離 | ≤ 5000 m (Dependent on the data rate and the protocol used) |
| 伝送媒体 | 2-wire twisted pair, shielded |
| 伝送方法 | CSMA/CA |
| 保護の程度 | IP20 |
| 電気的絶縁 | VCC // TBUS // CAN A // CAN B |
| 供給電圧範囲 | 10 V DC ... 30 V DC (via pluggable COMBICON screw terminal block) |
| 終端抵抗 | 124 Ω (Integrated and ready to be switched) |
| ビット歪み、入力 | ± 35 % |
| バスデバイスの数 | ≤ 64 (per potential segment) |
| 規格・規制 | EN 61000-4-2 |
| ビット歪み、出力 | < 6.25 % |
| 接点スイッチングタイプ | N/C contact |
| 公称電源電圧 | 24 V DC |
| 最大消費電流 | 80 mA |
| 定格絶縁電圧 | 85 V DC (In accordance with EN/IEC 60079-7, Annex H) |
| 最大スイッチング電圧 | 30 V DC |
| 最小スイッチング電圧 | 10 V DC |
| 連続電流の制限 | 500 mA |
| 標準消費電流 | 55 mA (24 V DC) |
| 電磁両立性 | Conformance with EMC Directive 2014/30/EU |
| 周囲温度(動作) | -20 °C ... 60 °C |
| 許容湿度(動作) | 30 % ... 95 % (non-condensing) |
| ステータスと診断インジケーター | LEDs: VCC (supply voltage), NET A (Mod/Net status port A), NET B (Mod/Net status port B), ACT (activity/data traffic) |
| 単線/端子ポイント、フレキシブル | 0.2 mm² ... 2.5 mm² |
| 単一導体/端子点、剛性 | 0.2 mm² ... 2.5 mm² |
| 周囲温度(保管/輸送) | -40 °C ... 85 °C |
| テスト電圧データインターフェース/電源 | 1.5 kVrms(50 Hz, 1 min.) |
| 最大AWG導体断面積、フレキシブル | 14 |
| 最小AWG導体断面積、フレキシブル | 24 |
| 単線/端子点、リジッド AWG 最大。 | 14 |
| 単線/端子点、リジッド AWG 最小。 | 24 |
| 公称条件での最大消費電力 | 1.32 W |
| コーティングの適用を損なう可能性のある物質を含まない | VDMA 24364:2018-05 |
技術仕様と性能データ
設置・操作ガイド