

| パラメータ | 価値 |
|---|---|
| Light grid | |
| 注記 | G3 |
| 深さ | 113.6 mm |
| ショック | 10g for Δt = 16 ms (continuous shock, 1000 shocks in each space direction) |
| 幅 | 45.2 mm |
| 身長 | 107.74 mm |
| 電圧 | 24 V DC (via A1) |
| プラグイン可能 | yes |
| インターフェース | DIN rail TBUS for connection to the master module, not supplied as standard |
| 抵抗負荷 | min. 50 Ω (Observe limiting continuous current) |
| 応用 | Emergency stop |
| 指定 | A1/A2 |
| フィルター時間 | typ. 5 ms (at A1 in the event of voltage dips at Us) |
| テストパルス | < 120 µs (Test pulse width of low test pulses) |
| ケーブル長 | max. 100 m (per input) |
| 製品タイプ | Safety device |
| 再起動時間 | min. 5 s (Boot time) |
| 取り付けタイプ | DIN rail mounting |
| 応答時間 | see user manual |
| 停止カテゴリ | 0 |
| 識別 | CE-compliant |
| 突入電流 | < 14.4 A (Δt = 0.5 ms at Us) |
| ステータス表示 | 1 x LED (green), 1 x LED (orange), 1 x LED (blue) |
| 漏れ電流 | max. 500 µA |
| エラー表示 | 2 x LED (red) |
| ハウジング材質 | Polyamide PA non-reinforced |
| 最大高度 | ≤ 2000 m (Above sea level) |
| 入力数 | 8 |
| 保護クラス | III |
| 剥ぎ取り長さ | 10 mm |
| 接続方法 | Push-in connection |
| 取り付け位置 | vertical or horizontal |
| 出力数 | 4 |
| 出力の説明 | Safety-related digital outputs |
| 保護回路 | Serial protection against polarity reversal |
| 伝送速度 | 100 Mbps (Full duplex) |
| 消費電流 | typ. 3.7 mA (typically with US) |
| 放電回路 | Yes, internal |
| 最大誘導負荷 | max. 2.4 mH |
| スイッチング周波数 | max. 1/4 x tCycle[Hz] |
| 保護の程度 | IP20 |
| 最大容量負荷 | max. 820 nF |
| 組み立て説明書 | Observe derating |
| 接続数 | 2 |
| 振動(操作) | 10 Hz ... 150 Hz, 2g |
| 通信プロトコル | PROFINET |
| 最大突入電流 | 1.1 A (Δt = 3 s at Us) |
| 公称動作モード | 100% operating factor |
| 公称出力電圧 | 24 V DC (Supply via A1) |
| パフォーマンスレベル(PL) | e (2-channel wiring) |
| 米国の電力消費量 | typ. 2.88 W (Outputs inactive) |
| 入力の説明 | Safety-related digital inputs |
| 定格絶縁電圧 | 250 V AC |
| 短絡保護 | no |
| 動作電圧表示 | 1 x green LED |
| 導体断面積AWG | 24 ... 16 |
| 連続電流の制限 | 400 mA (per channel) |
| 公称出力電圧範囲 | 18.5 V DC ... 28.1 V DC (US- 0,7 V) |
| 安全度水準(SIL) | 3 |
| 導体断面積は剛性 | 0.2 mm² ... 2.5 mm² |
| 入力電流範囲「0」信号 | < 0.2 mA |
| 入力電圧範囲「0」信号 | 0 V DC ... 5 V DC |
| 入力電圧範囲「1」信号 | 11 V DC ... 28.8 V DC |
| 定格サージ電圧/絶縁 | Basic insulation 4 kV between all current paths and housing |
| 周囲温度(動作) | -10 °C ... 70 °C (observe derating) |
| 定格制御電源電流 IS | 120 mA (RMS typ. inactive for all outputs) |
| 導体断面積が柔軟 | 0.2 mm² ... 2.5 mm² |
| 電源オフ時の出力電圧 | < 0.3 V |
| 周囲温度(保管/輸送) | -20 °C ... 85 °C |
| 定格制御回路電源電圧(米国) | 19.2 V DC ... 28.8 V DC |
| 設備設置場所の最小保護等級 | IP54 |
| 最大許容湿度(保管/輸送) | 95 % (non-condensing) |
| 最大許容全導体抵抗 | max. 1.2 kΩ (Input and reset circuit at US) |
| 最大許容相対湿度(動作) | 95 % (non-condensing) |
| 公称条件での最大消費電力 | 9.85 W (with max. permissible load) |
技術仕様と性能データ
設置・操作ガイド