

| パラメータ | 価値 |
|---|---|
| GTIN | 4046356553322 |
| 注文キー | 2986575 |
| カタログページ | Page 287 (C-6-2017) |
| 深さ(注) | 114.5 mm |
| 梱包単位 | 1 pc |
| 幅(注) | 17.5 mm |
| (入力データ) | 150 mA Fast-blow (N/C contact) |
| 高さ(注) | 99 mm |
| (出力データ) | IP54 |
| 原産国 | DE (Germany) |
| プラグ可能(一般) | Yes |
| 関税番号 | 85364900 |
| (周囲条件) | Test pulse rate = 15 x Test pulse width |
| ねじ山(一般) | M3 |
| 正味重量(出力データ) | 108.77 g |
| 出力ヒューズ(入力データ) | 10 A gL/gG (N/O contact) |
| リレータイプ(出力データ) | Electromechanical relay with forcibly guided contacts in accordance with EN 50205 |
| 連絡先の種類(入力データ) | 2 enabling current paths |
| カテゴリ(接続データ) | 1 (Diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90 %) |
| ストリップ長さ(一般) | 7 mm |
| 接続方法(一般) | Screw connection |
| ハウジングカラー(出力データ) | yellow |
| 取付タイプ(出力データ) | DIN rail mounting |
| (基準および規制) | For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration” |
| 連絡先資料(入力データ) | AgCuNi, + 0.2 µm Au |
| 指定(接続データ) | EN 50156 |
| 最大高度(寸法) | ≤ 2000 m (Above sea level) |
| ハウジング材質(出力データ) | PBT |
| 平方総電流(入力データ) | 50 A2(observe derating) |
| 取り付け位置(出力データ) | any |
| 停止カテゴリ(接続データ) | 0 |
| スイッチング容量(入力データ) | min. 75 mW |
| フィルター時間(周囲条件) | max. 5 ms (at A1 in the event of voltage dips at Us) |
| 保護等級(出力データ) | IP20 |
| 回復時間(周囲条件) | 1 s |
| 突入電流(周囲条件) | max. 100 mA |
| 最大突入電流(入力データ) | 5 A (N/O contact) |
| 突入電流、最小(入力データ) | 5 mA (N/O contact / N/C contact) |
| 機械的耐用年数(入力データ) | 10x 106cycles |
| 公称動作モード(出力データ) | 100% operating factor |
| 1個あたりの重量(梱包を除く) | 108.770 g |
| 中国RoHS(規格と規制) | Environmentally Friendly Use Period = 50 |
| 最大スイッチング電圧(入力データ) | 250 V AC/DC (N/O contact / N/C contact, observe the load curve) |
| 最小スイッチング電圧(入力データ) | 15 V AC/DC (N/O contact / N/C contact) |
| 保護回路(周囲条件) | Surge protection Suppressor diode, 33 V (A1 - A2) |
| 連続電流の制限(入力データ) | 5 A (N/O contact, pay attention to the derating) |
| パフォーマンスレベル(PL)(接続データ) | c (Diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90 %) |
| 典型的な放出時間(周囲条件) | 50 ms |
| 導体断面積 AWG 最大 (一般) | 12 |
| 導体断面積AWG最小値(一般) | 24 |
| 衝撃(安全関連特性データ) | 15g |
| 周囲温度(動作)(寸法) | -20 °C ... 55 °C (observe derating) |
| 導体断面積(固体最大)(一般) | 2.5 mm² |
| 導体断面積(最小)(一般) | 0.2 mm² |
| 米国における消費電力(周囲条件) | typ. 1.32 W |
| 利用制限(主要商業データ) | 1 |
| 動作電圧表示(周囲条件) | 1 x yellow LED |
| 安全度水準(SIL)(接続データ) | 2 |
| 導体断面積最大可とう性(一般) | 2.5 mm² |
| 導体断面積(フレキシブル)最小値(一般) | 0.2 mm² |
| 当社での標準的な開始時間(周囲条件) | 50 ms |
| 適合性(安全関連特性データ) | CE-compliant |
| 指定(安全関連特性データ) | Air clearances and creepage distances between the power circuits |
| 最大スイッチング周波数(周囲条件) | 0.5 Hz |
| 遮断定格(抵抗負荷)最大(入力データ) | 120 W (24 V DC, τ = 0 ms, N/C contact: 2.4 W) |
| 周囲温度(保管/輸送)(寸法) | -40 °C ... 70 °C |
| 定格制御電源電流 IS (周囲条件) | typ. 55 mA |
| 汚染度(安全関連特性データ) | 2 |
| 最大遮断定格(誘導負荷)(入力データ) | 72 W (24 V DC, τ = 40 ms, N/C contact: 2.4 W) |
| 設備設置場所の最小保護等級(出力データ) | IP54 |
| 過電圧カテゴリー(安全関連特性データ) | III |
| 最大許容湿度(保管/輸送)(寸法) | 75 % (on average, 85% infrequently, non-condensing) |
| 規格・規制(安全関連特性データ) | DIN EN 50178/VDE 0160 |
| 振動(動作)(安全関連特性データ) | 10 Hz ... 150 Hz, 2g |
| 最大許容相対湿度(動作時)(寸法) | 75 % (on average, 85% infrequently, non-condensing) |
| 定格制御回路電源電圧 US (周囲条件) | 24 V DC -15 % / +10 % |
| 定格絶縁電圧(安全関連特性データ) | 250 V AC |
| 安全度水準クレーム限界(SIL CL)(接続データ) | 1 (max. 10% of the entire SIL; diagnostic coverage (DC) of the control unit at A1/A2 must be ≥ 90% ) |
| 定格サージ電圧/絶縁(安全関連特性データ) | Safe isolation, reinforced insulation 6 kV between the control circuits (A1/A2), (31/32), (13/14, 23/24) |
技術仕様と性能データ
設置・操作ガイド